How To Hook Up An Ignition Coil. The 12 volt wire from the ignition switch is also connected to that end of one of the coils. Connect the red cable from the multimeter to PIN 2 and the black cable to engine ground -.
This is the normal run position of the switch. The connection is accomplished through a cap and rotor. Michelle Schaefer began writing in 1998 for The.
Michelle Schaefer began writing in 1998 for The.
There is some misconception about ignition coil polarity and how important it may be or not. 8-cylinder ignition systems must be used with a coil that has between 15 and 20 Ohms. One end of the primary of each coil should be connected together with the supplied jumper. William Kinsey lives in Concord NC.
